← Company Updates
FROM OUR FACTORY
PCB Industry Analysis

Should a 0.4 mm WLCSP PCB Use NSMD Pads When Solder-Mask Webs Are Tight?

A 0.4 mm-pitch WLCSP land pattern can leave very little solder mask between adjacent openings. Check the exact package drawing and fabrication limits before approving the PCB layout.

Published byJay ZhangInternational Business Development Manager
8views
Should a 0.4 mm WLCSP PCB Use NSMD Pads When Solder-Mask Webs Are Tight?

TL;DR For Texas Instruments’ 0.4 mm-pitch Micro SMDxt WLCSP example, non-solder-mask-defined (NSMD) pads are preferred, but the recommended openings leave only a 0.075 mm nominal gap between adjacent openings. A buyer should approve the land pattern only after the PCB fabricator and assembler confirm how that gap will be made and inspected.

Why the mask opening matters

TI’s AN-1412 application report, revised April 2013, recommends a 0.225 ± 0.02 mm copper pad and a 0.325 ± 0.02 mm solder-mask opening for its 0.4 mm-pitch NSMD example. Subtracting the nominal opening diameter from the pitch leaves 0.075 mm between adjacent openings before fabrication tolerances and mask registration are considered. TI’s current packaging FAQ also states that NSMD pads are preferred for its WCSP packages because of copper-etch control and reduced stress concentration.

These dimensions describe TI’s package example, not every 0.4 mm WLCSP or a guaranteed PCB manufacturing limit. A different device may have a different ball size or land-pattern requirement.

What to approve before ordering

First, obtain the selected device’s latest package drawing and confirm its copper-pad and mask-opening dimensions. Then ask the PCB fabricator whether separate mask webs can be produced and inspected at the required tolerances, or whether a merged opening needs engineering approval. Finally, have the assembler review the resulting land pattern, stencil and reflow process against the device’s assembly guidance.

JETFGO’s published PCB capabilities page describes engineering review of design files and manufacturing tolerances before production. Feasibility for this particular land pattern requires a project-specific review.

References Texas Instruments, AN-1412 Micro SMDxt Wafer Level Chip Scale Package, SNVA131K, revised April 2013: https://www.ti.com/lit/an/snva131k/snva131k.pdf Texas Instruments, Quality, reliability & packaging FAQs, undated live page accessed November 9, 2026: https://www.ti.com/en-us/quality-reliability/faqs

Related JETFGO pages PCB manufacturing capabilities: https://jetfgo.online/en/capabilities

Comments0
JETFGO / COMMUNITY

Join the conversation

Your comment will appear after review. Your email is never shown publicly.

Submitted for review

Received. Your comment will appear after review.

Contact Us