← Company Updates
FROM OUR FACTORY
PCB Industry Analysis

Can a 1.6 mm Six-Layer PCB Use a Standard Stackup Instead of Thin Cores?

For a six-layer, 1.6 mm PCB, a custom thin-core stackup may add fabrication cost. Compare stackups before quotation, while keeping electrical and mechanical requirements fixed.

Published byJay ZhangInternational Business Development Manager
4views
Can a 1.6 mm Six-Layer PCB Use a Standard Stackup Instead of Thin Cores?

TL;DR For buyers specifying a six-layer, 1.6 mm PCB, the decision is whether thin cores are required by the design or simply carried forward in the drawing. Ask engineering and the fabricator to compare a standard stackup with the specified construction before requesting a final quote. Change it only after the electrical and mechanical requirements are checked.

Why the stackup changes the comparison

In an April 5, 2023 manufacturing-cost webinar, Würth Elektronik compared two six-layer, 1.6 mm constructions. Its standard example used two 0.36 mm cores and six 2116 prepregs, with a price indicator of 100%. Its custom example used two 0.10 mm cores, two 2116 prepregs and eight 7628 prepregs, with an indicator of 116%. Würth attributed the difference to handling thin laminate and using four additional prepregs. This is a relative indicator for its example, not a current market price, a universal 16% premium or a JETFGO quote.

What the buyer should decide

First, identify why the drawing specifies the thin-core construction. A required trace-to-plane distance, impedance target, connector geometry or finished thickness can prevent a direct substitution. Analog Devices explained in a May 15, 2025 RF design article that dielectric thickness affects transmission-line impedance and that final pressed thickness must meet the line's tolerance. Its RF example does not set a tolerance for every industrial board, but it shows why a lower-cost stackup cannot be approved from layer count and overall thickness alone.

Next, request two buildable stackups against the same board outline, copper requirements, material grade, finished thickness and test requirements. Have the designer check the affected traces and planes, and ask the fabricator to state any changes to impedance coupons, drilling or lamination. Compare actual project quotations only after both constructions pass that review. If the thin cores are functionally required, keep them in the controlled drawing rather than accepting an unverified substitution.

JETFGO's English High Speed PCB page says its engineers review stackup, impedance, material and manufacturing feasibility before production. That public statement supports requesting a project-specific review; it does not establish a standard six-layer price or approve a stackup change for a particular design.

References Würth Elektronik, How does your PCB layout influence the costs in PCB manufacturing?, webinar slides, April 5, 2023: https://www.we-online.com/files/pdf1/webinar-91-how-does-your-pcb-layout-influence-the-costs-in-pcb-manufacturing-cbt-en.pdf Analog Devices, High Fidelity PCB Design for Multichannel Beamformers, Part 1: Return Loss, May 15, 2025: https://www.analog.com/en/resources/technical-articles/high-fidelity-pcb-design-for-multi-channel-beamformer-part-1.html

Related JETFGO pages JETFGO High Speed PCB: https://jetfgo.online/en/products/high-speed-pcb

Comments0
JETFGO / COMMUNITY

Join the conversation

Your comment will appear after review. Your email is never shown publicly.

Submitted for review

Received. Your comment will appear after review.

Contact Us